LUND 67470 Manual Original página 9

GB
of the power cord and plug must be carried out by an authorised service centre of the manufacturer.
Instructions for the use of the appliance
WARNING! The cooktop surface can be hot after use. Do not touch it, as it may cause severe burns. Allow the cooktop to cool
down.
When preparing dishes which may spread hot food fragments, personal protective equipment should be worn to protect from
burns.
Make sure that the fl oor near the appliance is not slippery. This will prevent slipping, which can cause serious injuries.
Observe the food at all times and prevent it from burning during its preparation. Food left unattended can burn, which can cause
fi re and serious burns.
When preparing dishes, touch the cooktop surface only with utensils made of wood or plastic. The utensils should be able to
withstand the temperature generated by the cooktop. It is forbidden to remove and distribute food using hands.
If any food is left on the cooktop during or after preparation, remove the food remains before preparing another dish. Food remains
can be burned, causing smoke, unpleasant smell, and aff ect the taste of the prepared food. They may also be the cause of fi re.
Use utensils made of wood or plastic able withstand the temperature generated by the cooktop. Do not use sharp or metal uten-
sils. Such utensils can damage the cooktop surface.
If the preparation of a dish requires the use of oil, spread it on the surface of the cooktop with a soft brush. The appliance is not
used for preparing dishes by deep-frying.
APPLIANCE OPERATION
Installation, start-up and operation of the appliance
The appliance must be unpacked and all parts of the packaging completely removed. It is recommended to keep the packaging,
as it can be helpful for further transport and storage of the appliance.
Prepare the appliance according to the instructions specifi ed in the "Product Maintenance" section.
The appliance is activated by means of the temperature control knob. Turning the knob until it stops in the direction of the minimum
temperature mark, "MIN", and setting it in the position marked with "0" means that the cooktop heating is switched off .
When the product is connected to the power supply, both indicator lights will come on, which means that the appliance is properly
powered. Rotate the temperature control knob in the direction of the maximum temperature mark - "MAX". This will start the heat-
ing of the cooktop. The green indicator light will go out. When the cooktop is heated to the set temperature, the green indicator
light will come on again.
The appliance has a built-in thermostat, which allows to automatically maintain the set temperature. Each time the cooktop begins
heating up, the green indicator light goes out.
The frequency at which the heater switches is determined by the set temperature and the ambient temperature. The higher the set
temperature and the lower the ambient temperature, the more often the heater will be switched on.
The pancake maker is equipped with a spatula and a paddle (II), which facilitate the distribution of pancake dough on the cooktop
surface. The accessories are made of materials which are safe for the cooktop surface.
The cooktop heats up to a high temperature, contact with unprotected body can lead to serious burns. When preparing food, care
should be taken not to touch the cooktop, and the cooked food should checked using appropriate utensils, e.g. pliers or paddles
made of plastic or wood.
When selecting utensils, it is important to take into account whether they can withstand the temperature generated by the cooktop.
Do not use metal utensils or utensils with sharp edges. Such utensils can damage the cooktop surface.
Appliance maintenance
CAUTION! All maintenance must be carried out with the appliance switched off . To do this, unplug the power cord from the
socket.
The appliance is used to prepare food placed directly on the cooktop, therefore care must be taken to maintain proper hygiene so
that the preparation of food is safe.
The cooktop can be protected with a preservative agent for transport and storage. Before fi rst use, after cleaning, heat the cooktop
to its maximum temperature and allow all residues of the preservative agent to evaporate. The evaporating preservative agent can
cause smoke, which is a normal phenomenon. Therefore, evaporation should be carried out in a place with effi cient ventilation. Do
not inhale the vapours of the preservative agent.
After the evaporation is fi nished and the smoke stops fl owing, disconnect the appliance from the power supply, wait until the
cooktop cools down completely and clean it again with a cleaning agent. Only then can the cooktop be used for food preparation.
Clean the cooktop and other parts of the appliance with a cloth soaked in a water solution of a mild dishwashing detergent.
Remove any residues of the solution with a cloth soaked in water. After cleaning, wipe the appliance dry. The cooktop should
be cleaned after each use, once it cooled down completely. Clean any food residue remaining on the cooktop to prevent it from
burning when used again, and to prevent the machine's performance from being impaired.
O R I G I N A L I N S T R U C T I O N S
9