Toto MS614164CEF Instrucciones Para La Instalación página 4

TOILET TANK FILL VALVE INSTRUCTIONS
Cyclone / G-Max / E-Max
® ®
WARNING! DO NOT USE IN-TANK BOWLCLEANERS
The use of high concentration of chlorine or chlorine-related products can
seriously damage fittings in the tank. This damage can cause leakage and
property damage. TOTO shall not be responsible or liable for any tank fit-
ting failure or damage caused by the use of in-tank bowl cleaners.
INSTALLATION
1. Shut OFF water supply to toilet.
2. Flush toilet and remove remaining water from tank with a sponge.
3. Remove the water supply connection at the fill valve.
4. Remove old fill valve and use damp sponge to clean hole in tank.
5. Place new fill valve inside tank hole.
6. Thread mounting nut onto fill valve shank and tighten nut.
Note: DO NOTOVERTIGHTEN. Be sure to install fill valve in a
position that does not interfer with the trip lever operation.
7. Connect water supply to fill valve shank and hand tighten only.
Note: DO NOTOVERTIGHTEN. These are plastic parts.
Never use pipe dope on any water supply connection.
8. Attach refill tube to fill valve nipple and clip other end of refill tube
to the overflow pipe.
9. Turn water supply ON and check for leaks outside the tank.
Note: As water fills the tank, water is also directed into the over-
flow tube via the refill tube. This additional flow of water is
critical to refilling your toilet's bowl. Once the water stops
filling the tank, some residual drops of water may drip from
the fill valve. This is NORMAL as these drops will subside.
WATER LEVEL ADJUSTMENT
Depending on the manufacturing plant, you may have one of two of
the following fill valves.
Type A
4
/ Power Gravity
® ®
WATER
LEVEL
Type B
For Type A fill valve, refer to water level (WL) setting
marked on the inner wall of the tank. Allow the water to fill
the tank. Turn the adjustment screw clockwise in the (+) direc-
tion to increase the water level height. Turn the adjustment
screw counter-clockwise in the (-) direction to decrease the
water level height. Flush the toilet to verify the correct water
level. Adjust as necessary.
WL
For Type B fill valve, there are no water level adjustments.
THE FILL VALVE HAS BEEN PRESET AT THE FACTORY.
WL
OPERATION (NOTE TO OWNER)
You have chosen a TOTO product that is superior in quality and
craftsmanship. Our toilet flushing systems are the best in the indus-
try. To insure that your toilet is performing correctly, always flush the
toilet with a full stroke of the trip lever to activate the flushing cycle.
A full stroke will guarantee that you are flushing with the power of a
TOTO.
If you need advice on your installation, feel free to contact one of our
Technical Support members at the number below.
TOTO USA, Inc. 1155 Southern Rd, Morrow, GA 30260
Tel.: (888) 295-8134 • Fax (800) 699-4889
www.totousa.com
Printed in USA ©TOTO USA Inc.
Top of Overflow Tube
Top of Overflow Tube