Double Insulation; Additional Safety Rules - Makita UB1102 Manual De Instrucciones

ENGLISH
(Original instructions)
1 Switch trigger
2 Lock button
3 Speed control screw
4 Higher
5 Lower
SPECIFICATIONS
Capacities
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s). The lightest and heaviest combination, according to EPTA-
Procedure 01/2014, are shown in the table.
Symbols
The followings show the symbols which may be used for
the equipment. Be sure that you understand their
meaning before use.
Read instruction manual.

DOUBLE INSULATION

Only for EU countries
Due to the presence of hazardous
components in the equipment, used
electrical and electronic equipment may
have a negative impact on the environment
and human health.
Do not dispose of electrical and electronic
appliances with household waste!
In accordance with the European Directive
on waste electrical and electronic equipment
and its adaptation to national law, used
electrical and electronic equipment should
be collected separately and delivered to a
separate collection point for municipal waste,
operating in accordance with the
environmental protection regulations.
This is indicated by the symbol of the
crossed-out wheeled bin placed on the
equipment.
Guaranteed sound power level according to
EU Outdoor Noise Directive.
Explanation of general view
6 Nozzle
7 Blower outlet
8 Pin
9 Dust bag
10 Suction inlet
Model
Air pressure
Max. air volume
No load speed
Overall length
Net weight
Safety class
UB1102
5.7 kPa
4.1 m
16,000 min
479 mm
END334-1
Sound power level according to Australia
NSW Noise Control Regulation
Intended use
The tool is intended for blowing dust.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
General Power Tool Safety Warnings
WARNING Read all safety warnings, instructions,
illustrations and specifications provided with this
power tool. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.

ADDITIONAL SAFETY RULES

1. Always use protective goggles, a cap and mask
when using the blower.
2. Never point the nozzle at anyone in the vicinity
when using the blower.
3. Always use the dust bag when collecting dust,
chips and the like.
11 Fastener
12 Limit mark
13 Brush holder cap
14 Screwdriver
UB1103
0 – 5.7 kPa
3
/min 0 – 4.1 m
–1
0 – 16,000 min
479 mm
1.9 – 2.2 kg
/II
3
/min
–1
ENE018-1
ENF002-2
GEA010-2
ENB017-2
3