Search Method - One for All URC-7525 Guia Del Usuario

--> If your device does not respond to the ONE FOR ALL after you have
tried all the codes listed for your brand.
--> If your brand is not listed at all.
The Search Method allows you to scan through all the codes contained in the
memory of the ONE FOR ALL.
Example: to search for your Television code:
1 Switch your television on (not on standby).
2
3
4
5
6
- To search for your Set-Top-Box, Digital Satellite, Cable Box, Freeview/DVB-T
Box press 9 9 2 (instead of 9 9 1) during step 3.
- Most TV's do not switch on pressing the POWER key. Please try pressing the
"TV-text off" key to switch your TV back on.
- If you cannot control your Television properly, please continue the Search
Method, you may be using the wrong Code.
6

Search Method

Press and hold the MAGIC key until the red light (LED
underneath the POWER) blinks twice. The LED will light
up once then twice.
In this example press 9 9 1 to search for your Television,
LCD-TV, Plasma-TV.
Next, press POWER.
Aim the ONE FOR ALL at your Television. Now press CH+ over
and over, until your Television turns off (every time you press
the CH+ key the ONE FOR ALL will send out a POWER signal
from the next code contained in the memory).
You may have to press this key many times (up to 150
times) so please be patient. If you skip past a code, you can
go to the previous code(s) by pressing the CH- key. Remember
to keep pointing the ONE FOR ALL at your Television while
pressing this key.
As soon as your television switches off, press MAGIC to store
the code.
Set Up
WWW .ONEFORALL.COM