Operation; Installing/Removing The Battery Pack - Ryobi P552 Manual Del Operador

WARNING:
Do not allow familiarity with tools to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes, resulting in possible
serious injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this tool. The use
of attachments or accessories not recommended can
result in serious personal injury.
APPLICATIONS
This product has been designed only for the purposes listed
below:
 Cross cutting wood and plastic (do not cut metals,
ceramics, or masonry products)
 Cross cutting miters, joints, etc. for picture frames mold-
ings, door casings, and fine joinery
 Bevel cutting and compound cutting
NOTE: The blade provided is fine for most wood cutting
operations, but for fine joinery cuts or cutting plastic, use
one of the accessory blades available from the dealer.
WARNING:
Before starting any cutting operation, clamp or bolt the
compound miter saw to a workbench or an approved
workstand. Never operate the miter saw on the floor or
in a crouched position. Failure to heed this warning can
result in serious personal injury.
WARNING:
To avoid serious personal injury, always push the miter
lock lever down securely and tighten the bevel lock knob
securely before making a cut. Failure to do so could re-
sult in movement of the control arm or miter table while
making a cut.
WARNING:
To avoid serious personal injury, keep hands outside the
no hands zone, at least 3 in. from the blade. Never perform
any cutting operation freehand (without holding workpiece
against the fence). The blade could grab the workpiece if
it slips or twists.
All manuals and user guides at all-guides.com

OPERATION

INSTALLING/REMOVING THE BATTERY
PACK
See Figure 23.
 Place battery pack in the saw. Align raised rib on battery
 Make sure the latches on each side of the battery pack
 Locate and depress the latches on each side of the bat-
 Remove the battery pack.
For complete charging instructions, refer to the Operator's
Manuals for your battery pack and charger.
19 – English
WARNING:
Do not start your compound miter saw without checking
for interference between the blade and the miter fence.
Damage could result to the blade if it strikes the miter
fence during operation of the saw. Failure to heed this
warning can also result in serious personal injury.
pack with groove inside saw.
snap in place and that the battery pack is secured in the
tool before beginning operation.
WARNING:
Always remove battery pack from your tool when you
are assembling parts, making adjustments, cleaning,
transporting, or when not in use. Removing battery pack
will prevent accidental starting that could cause serious
personal injury.
tery pack to release the battery pack from the saw.
DEPRESS LATCHES TO
RELEASE BATTERY PACK
LATCHE(S)
BATTERY
PACK
Fig. 23