Ryobi P552 Manual Del Operador página 23

 Grasp the stock firmly with one hand and secure it against
the fence. Use the optional work clamp or a C-clamp to
secure the workpiece when possible.
 Before turning on the saw, perform a dry run of the cutting
operation just to make sure that no problems will occur
when the cut is made.
 Grasp the saw handle firmly. Depress the switch lock
with thumb then squeeze the switch trigger. Allow several
seconds for the blade to reach maximum speed.
 Slowly lower the blade into and through the workpiece.
 Release the switch trigger and allow the saw blade to stop
rotating before raising the blade out of the workpiece. Wait
until the blade stops before removing the workpiece from
the miter table.
TO SUPPORT LONG WORKPIECES
See Figure 30.
Long workpieces need extra supports. Supports should be
placed along the workpiece so it does not sag. The support
should let the workpiece lay flat on the base of the saw and
worktable during the cutting operation. Use the optional work
clamp or a C-clamp to secure the workpiece.
All manuals and user guides at all-guides.com
OPERATION
23 – English
LONG
WORKPIECE
WORKPIECE
SUPPORTS
Fig. 30