Ryobi P552 Manual Del Operador página 8

KNOW YOUR COMPOUND MITER SAW
See Figure 1.
The safe use of this product requires an understanding of
the information on the tool and in this operator's manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
7-1/4 in. BLADE
A 7-1/4 in. blade is included with the compound miter saw.
It will cut materials up to 1-1/2 in. thick or 4-1/4 in. wide,
depending upon the angle at which the cut is being made.
BEVEL LOCK KNOB
The bevel lock knob securely locks your compound miter
saw at desired bevel angles. Loosen the bevel lock knob
to release the saw allowing the blade to be tilted for bevel
cuts. Tighten the knob to lock the saw in place. Positive stop
adjustment screws are located on each side of the saw arm.
These adjustment screws are for making fine adjustments
at 0° and 45°.
BLADE WRENCH STORAGE
See Figure 1.
A blade wrench is packed with the saw. One end of the
wrench is a phillips screwdriver and the other end is a hex
key. Use the hex key end when installing or removing blade
and the phillips end when removing or loosening screws. A
storage area for the blade wrench is located in the saw's base.
LASER GUIDE
See Figure 2.
When used properly, the laser guide makes accurate, preci-
sion cutting simple and easy.
MITER FENCE
The miter fence on the compound miter saw is used to secure
your workpiece when making all cuts.
MITER LOCK LEVER
See Figure 2.
The miter lock lever securely locks the saw at desired miter
angles. To adjust miter table, rotate the miter lock lever for-
ward to unlock the miter table. Rotate the lever toward the
back of the saw to lock the miter table.
POSITIVE STOPS ON MITER TABLE
Positive stops have been provided at 0°, 15°, 22-1/2°, 31.62°,
and 45°. The 15°, 22-1/2°, 31.62°, and 45° positive stops
have been provided on both sides of the miter table.
REAR BRACKET/CARRYING HANDLE
See Figure 2.
For convenience when carrying or transporting the miter saw,
there is a carrying handle at the rear of the saw. To transport,
turn off the saw and remove the battery pack, then lower
the saw arm and lock it in the down position. Lock the saw
arm by depressing the lock pin.
All manuals and user guides at all-guides.com
FEATURES
8 – English
TO
UNLOCK
TO
LOCK
MITER
LOCK LEVER
LASER SWITCH
LASER
GUIDE
"D" HANDLE
SAW ARM LOCKED
IN DOWN POSITION
LOCK
MITER
PIN
FENCE
REAR BRACKET/
CARRYING HANDLE
MITER
LOCK LEVER
Fig. 2