Installation - Electrolux EWIE08F3MMW Manual De Instrucciones

25 electrolux installation

Installation

La instalación debe ser llevada a cabo por personal calificado y de acuerdo
con las instrucciones indicadas por el fabricante. Su instalación incorrecta
podría ocasionar daños personales.
Remove package
Remove package and take out the bottom
board of the cabinet on the foam cover.
Open the lid of washer's door and take out
accessories.
A trial operation or washing on the foamed
cushion is strictly forbidden.
Installation of the bottom cover
Slightly tilt the machine forward, and insert
the bottom cover.
Installation of drain hose
Completely sleeve the drain hose over
the discharge drain.
Fix and tighten it with a clamp. (As
shown in the figure)
All manuals and user guides at all-guides.com
Base foamed
cushion
Installation of the water inlet hose
1. Check the tap mouth. Let the tap
to mate with the skirtlike nut of
water inlet hose.
2. Pull the skirtlike nut of one end of
the water inlet hose upwards, and
then screw into the tap tightly.
3. Grasp the water inlet hose by hand
and pull it downwards to see
whether it is secured.
4. Screw the nut on the other end of
the water inlet hose into the water
inlet of the washing machine to the
most.
After installation water inlet hose, do
not start the washing machine in
haste. First open the tap to create
certain water pressure in the hose to
check whether there is any leakage in
the connector on both ends. If the
pressure is too high, please shut the
tap a little to avoid water leakage.
Tightly screw another end of water
inlet hose on water inlet valve (with
rubber seal ring inside).
When tightening the clamping nut,
evenly apply the force and do not
twist the water inlet valve to avoid
breaking of water inlet valve joint.
installation electrolux 26
Skirtlike nut
Water inlet hose
Clamping
Cold water
nut
Hot water
Two ends of the
hose is jacinth