Technical Data; Installation - Electrolux EWG 127410 W Manual De Instrucciones

Ocultar thumbs Ver también para EWG 127410 W:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

22 electrolux
Problem
Spinning starts late or the machine does not
spin:
The machine makes an unusual noise:
No water is visible in the drum:
If you are unable to identify or solve the
problem, contact our service centre. Before
telephoning, make a note of the model, se-
rial number and purchase date of your ma-
chine: the Service Centre will require this
information.

TECHNICAL DATA

Dimensions
Electrical connection
Water supply pressure
Level of protection against ingress of solid particles and moisture
1)
Water supply
Maximum Load
Spin Speed
1) Connect the water inlet hose to a water tap with a 3/4'' thread.

INSTALLATION

UNPACKING
All transit bolts and packing must be re-
moved before using the appliance.
You are advised to keep all transit devices
so that they can be refitted if the machine
ever has to be transported again.
The electronic unbalance detection device has
cut in because the laundry is not evenly distrib-
uted in the drum. The laundry is redistributed by
reverse rotation of the drum. This may happen
several times before the unbalance disappears
and normal spinning can resume. If, after some
minutes, the laundry is still not evenly distributed
in the drum, the machine will not spin.
• Redistribute the laundry.
The machine is fitted with a type of motor which
makes an unusual noise compared with other
traditional motors. This new motor ensures a
softer start and more even distribution of the
laundry in the drum when spinning, as well as
increased stability of the machine.
Machines based on modern technology operate
very economically using very little water without
affecting performance.
Width / Height / Depth
Voltage
Overall power
Fuse
Frequency
Minimum
Maximum
Cotton
Maximum
1. After removing all the packaging, care-
Possible cause/Solution
596 / 820 / 544 mm
220-230 V
2000 W
10 A
50 Hz
0,5 bar (0,05 MPa)
8 bar (0,8 MPa)
IPX4
Cold water
7 kg
1200 rpm
fully lay machine on it's back to remove
the polystyrene base from the bottom.
Mod. ... ... ...
Prod. No. ... ... ...
Ser. No. ...

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido