Technical Data And Conformity; Applicable Standards And Regulations; Performance Data And Specifications - Zeiss Primostar 1 Manual De Instrucciones

ZEISS

9 Technical Data and Conformity

This chapter contains important technical data as well as information on the conformity.

9.1 Applicable Standards and Regulations

Observe all general and country-specific safety regulations as well as applicable environmental
protection laws and regulations.
The Microscope is in compliance with the requirements of the following regulations and direc-
tives:
2011/65/EU
2015/836/EU
98/79/EC
EN 55011
EN 61010-1 and IEC 61010-2-101
DIN EN 61326-1
DIN EN 61326-2-6:2013
EN 62471
The Microscope and its accessories have been classified as instrument category 9 (laboratory
equipment or comparable standard). It also comply, as applicable, with the EU-regulations
2011/65/EU (RoHS) and 2012/19/EU (WEEE).
European and International Directives / Standards: For more information on ISO and CSA certifi-
cates or CE Declarations of Conformity, contact your ZEISS Sales & Service Partner.
ZEISS works according to a certified Environment Management System according to ISO 14001.
The Microscope was developed, tested and produced in accordance with the valid regulations and
guidelines for environmental law of the European Union.

9.2 Performance Data and Specifications

The Microscope must only be operated in closed rooms. It is recommended to install the Micro-
scope in a dark room where artificial illumination, sunlight or other light sources cannot interfere
with image acquisition. The Microscope should not be installed near windows with direct sunlight
or radiators. Compliance with the installation requirements of the Microscope and the availability
of the requested supplies is the responsibility of the customer and has to be provided at the time
of installation. Due to continuous development, we reserve the right to change specifications
without notice.
The Microscope must be plugged into a properly installed power socket with protective earth con-
tact using the supplied mains cable. The protective earth connection must not be impaired by the
use of extension cables.
Info
Your ZEISS Sales & Service Partner will provide you with the detailed installation requirements.
Instruction Manual ZEISS Primostar 1 | en-US | Rev. 2 | 415501-7021-111
9 Technical Data and Conformity | 9.1 Applicable Standards and Regulations
RoHS Directive
IvD Directive
Noise emission according to CISPR 11 Group 1 Class B
intended use in industrial environment
Safety requirements for electrical equipment for mea-
surement, control, and laboratory use
Electrical equipment for measurement, control and
laboratory use – EMC requirements / IVD requirements
Photobiological safety of lamps and lamp systems
Compliance with the limit values in accordance with
EN 62471 Risk group 1 (Exempt risk group viewing
from ocular)
27