General Information; Text Conventions And Link Types; Programming And Macros; Further Applicable Documents - Zeiss Primostar 1 Manual De Instrucciones

ZEISS

1 General Information

This Instruction Manual is considered to be part of the Primostar 1. Herein after referred to as Mi-
croscope.
This Instruction Manual contains basic steps and safety information that must be observed during
operation and maintenance. Therefore, the Instruction Manual must be read by the operator prior
to commissioning and must always be available at the place of use of the Microscope. This In-
struction Manual is an essential part of the Microscope and, if the Microscope is resold, the In-
struction Manual must remain with the Microscope or be handed over to the new owner.

1.1 Text Conventions and Link Types

The following text conventions and link types are used:
Text convention
Click Start.
Press the
Press
Press
Select
lock.
Text input

Programming and Macros

Tab. 1: Text convention
Link type
See: Text Conventions and Link Types [
https://www.zeiss.com/corporate/int/
home.html
Tab. 2: Link types

1.2 Further Applicable Documents

Please take also note of the following documents:
Brochures and For Brochures, ISO certificates, CSA certificates and EU declarations of conformity ask your ZEISS
Certificates Sales & Service Partner.
Local and National Local and national health and safety regulations should be adhered to for the site and the use of
health and safety the Microscope. Please consult with your ZEISS Sales & Service Partner in the event of these regu-
regulations
lations conflicting with the installation requirements of the Microscope.
Safety data sheets Observe the enclosed safety data sheets. The instructions and guidelines given in the respective
safety data sheets must be complied with.
System and 3rd The Microscope can be configured in many ways. Information about the individual components,
Party Components, enhancements and accessories can be obtained from your ZEISS Sales & Service Partner. Also refer
Accessories to the 3rd Party documentation of the manufacturer.
Instruction Manual ZEISS Primostar 1 | en-US | Rev. 2 | 415501-7021-111
STANDBY button.
[Enter] on the keyboard.
<Ctrl+Alt+Del>
Tools > Goto Control Panel > Air-
1 General Information | 1.1 Text Conventions and Link Types
Meaning
The names of controls and important infor-
mation are shown in bold letters.
Press several keys on the keyboard simultane-
ously.
Follow a path in the software.
Text to be entered by the user
Anything typed in literally during program-
ming, including, for example, macro codes,
keywords, data types, method names, vari-
ables, class names, and interface names.
Meaning
}
5]. Link to further information for this topic.
Link to a website on the internet.
5