First Operating Steps; Prerequisites For Commissioning And Operation; Switching On The Microscope; Adjusting The Position Of The Eyepieces - Zeiss Primostar 1 Manual De Instrucciones

5 First Operating Steps | 5.1 Prerequisites for Commissioning and Operation

5 First Operating Steps

This chapter describes the switching on/off as well as the first operating steps with the Micro-
scope.
Info
Additional information and detailed descriptions are available in the further applicable docu-
ments, or ask your ZEISS Sales & Service Partner.
Info
Further information on the software and its operation is available in the software's online help.

5.1 Prerequisites for Commissioning and Operation

The following basic prerequisites are necessary for commissioning and operation:
§
§
§
§

5.2 Switching On the Microscope

Prerequisite
ü
Procedure 1. Turn the light intensity knob.
2. Adjust the illumination to the desired intensity.

5.3 Adjusting the Position of the Eyepieces

Info
The adjustment of the interpupillary distance is correct when you see only one round image
while looking through the two eyepieces.
Procedure 1. Set the interpupillary distance by rotating the
18
The Instruction Manual was read prior to commissioning or operation and kept for further
use.
Chapter Safety is read and understood.
Operator is acquainted with the general Windows
If required: Basic training and safety briefing successfully completed.
The microscope is connected to the mains [
à The selected intensity is indicated by the light-emitting diodes on the stand.
eyepiece tubes symmetrically toward or away
from one another.
®
-based programs.
}
17].
Instruction Manual ZEISS Primostar 1 | en-US | Rev. 2 | 415501-7021-111
ZEISS