Nokia N Serie Manual Del Usuario página 123

In an ad-hoc network, all devices must use the same
WLAN network name.
WLAN security mode—Select the encryption used: WEP,
802.1x (not for ad hoc networks), or WPA/WPA2. If you
select Open network, no encryption is used. The WEP,
802.1x, and WPA functions can be used only if the network
supports them.
WLAN security settings—Enter the settings for the selected
security mode:
Security settings for WEP:
• Wep key in use—Select the WEP key number. You can
create up to four WEP keys. The same settings must be
entered on the wireless LAN access point device.
• Authentication type—Select
authentication type between your device and the wireless
LAN access point device.
• WEP key settings—Enter
the key), WEP key format (ASCII
WEP key (the WEP key data in the selected format).
Open or Shared for the
WEP encryption (length of
or Hexadecimal), and
• EAP plug-in settings (only for EAP)—Enter the settings
as your service provider instructs.
• Pre-shared key (only for
password. The same password must be entered on the
wireless LAN access point device.
• WPA2 only mode (only for WPA/WPA2)—Select
whether Temporal Key Integrity Protocol (TKIP) is used.
Homepage—Define a home page.
Select Options > Advanced settings
IPv4 settings: Phone IP address
device), Subnet mask (the subnet IP address),
gateway (the gateway), and
addresses of the primary and secondary DNS server.
Contact your internet service provider for these addresses.
IPv6 settings > DNS address—Select Automatic,
Well-known, or User defined.
Ad-hoc channel (only for Ad-hoc)—To enter a channel
number (1-11) manually, select
Pre-shared key)—Enter a
and from the following:
(the IP address of your
Default
DNS address. Enter the IP
User defined.