3
The setting lever (2) allows the throttle
trigger (3) to be locked in the full throttle
position during operation.
Adjusting the choke knob
If the engine is cold
Set the choke knob to g
N
If the engine is warm
Set the choke knob to <
N
Also use this setting if the engine has
been running but is still cold.
BG 56, BG 56 C, BG 66, BG 86, BG 86 C, SH 56, SH 56 C, SH 86, SH 86 C
Cranking
Place the unit on the ground.
N
Make sure you have a firm footing:
N
Hold the unit firmly with your right
hand on the housing and press
down.
Hold the starter grip with your left
N
hand.
Version with Easy2Start
Pull the starter grip steadily.
N
Version without Easy2Start
Pull the starter grip slowly until you
N
feel it engage and then give it a brisk
strong pull.
NOTICE
Do not pull out the starter rope all the
way – it might otherwise break.
Do not let the starter grip snap back.
N
Guide it slowly back into the housing
so that the starter rope can rewind
properly.
As soon as the engine runs
Blip the throttle trigger (3) – the
N
choke knob moves to the run
position F – the engine returns to idle
speed.
English
3
17