Spark Plug - Stihl BG 56 Manual De Instrucciones

Ocultar thumbs Ver también para BG 56:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Standard setting B
Turn high speed screw (H)
N
counterclockwise as far as stop (no
more than 3/4 turn).
Turn the low speed screw (L)
N
carefully clockwise as far as stop,
then turn it back 3/4 turn.
Adjusting Idle Speed
Carry out the standard setting.
N
Start and warm up the engine.
N
Engine stops while idling
Turn the idle speed screw (LA)
N
clockwise until the engine runs
smoothly.
BG 56, BG 56 C, BG 66, BG 86, BG 86 C, SH 56, SH 56 C, SH 86, SH 86 C
Erratic idling behavior, poor acceleration
(even though standard setting of low
speed screw is correct)
Idle setting is too lean
Turn the low speed screw (L)
N
counterclockwise, no further than
stop, until the engine runs and
accelerates smoothly.
Erratic idling behavior, engine speed
drops when swinging the machine
Idle setting is too rich
Turn the low speed screw (L)
N
clockwise (1/8 of a turn or 45° at a
time) until the engine runs smoothly
and accelerates well.
It is usually necessary to change the
setting of the idle speed screw (LA) after
every correction to the low speed
screw (L).
Fine Tuning for Operation at High
Altitude
A slight correction of the setting may be
necessary if engine does not run
satisfactorily:
Carry out the standard setting.
N
Warm up the engine.
N
Turn high speed screw (H) slightly
N
clockwise (leaner) – no further than
stop.
NOTICE
After returning from high altitude, reset
the carburetor to the standard setting.
If the setting is too lean there is a risk of
engine damage due to insufficient
lubrication and overheating.

Spark Plug

If engine is down on power, difficult to
start or runs poorly at idling speed, first
check the spark plug.
Fit a new spark plug after approx. 100
operating hours or earlier if the
electrodes are badly eroded.
Wrong fuel mix (too much engine oil in
the gasoline), a dirty air filter and
unfavorable running conditions (mostly
at part throttle etc.) affect the condition
of the spark plug. These factors cause
deposits to form on the insulator nose
which may result in trouble in operation.
Removing the spark plug
1
Pull off the spark plug boot (1).
N
Unscrew the spark plug.
N
English
21

Hide quick links:

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Bg 66Bg 86Sh 56Sh 86

Tabla de contenido