Setup 6: Turn On The Monitor And Computer; If No Picture Appears On Your Screen; Setup 7:Adjust The Tilt And Height - Sony SDM-H246W Manual De Instrucciones

Setup 6: Turn on the monitor and
computer
1 Press the 1 (power) switch.
1 (power) illuminates.
2 Turn on the computer.
3 Press the INPUT button to select the desired input
signal.
The selected input's picture appears on the screen.
For more information, see "Selecting the input signal" on
page 13.
The installation of your monitor is complete. If necessary, use the
monitor's controls to adjust the picture (page 14).

If no picture appears on your screen

• Check that the power cord and the video signal cable are
properly connected.
• If "No Input Signal" appears on the screen:
– The computer is in the power saving mode. Try pressing any
key on the keyboard or moving the mouse.
– Check that the input signal setting is correct by pressing
INPUT button (page 13).
• If "Cable Disconnected" appears on the screen:
– Check that the video signal cable is properly connected.
– Check that the input signal setting is correct by pressing
INPUT button (page 13).
• If "Out Of Range" appears on the screen, reconnect the old
monitor. Then adjust the computer's graphics board within the
following ranges.
illuminates
10
Analog RGB
Horizontal
28–92 kHz
frequency
Vertical
56–85 Hz
frequency
Resolution
* Only when the vertical frequency is set to 60 Hz.
For more information about on-screen messages, see "Trouble
symptoms and remedies" on page 24.
No need for specific drivers
The monitor complies with the "DDC" Plug & Play standard and
automatically detects all the monitor's information. No specific driver
needs to be installed on the computer.
The first time you turn on your computer after connecting the monitor, the
setup Wizard may appear on the screen. In this case, follow the on-screen
instructions. The Plug & Play monitor is automatically selected so that
you can use this monitor.
The vertical frequency is set to 60 Hz.
Since flickers are unobtrusive on the monitor, you can use it as it is. You
do not need to set the vertical frequency to any particular high value.

Setup 7:Adjust the tilt and height

Adjust the position of the monitor
This monitor can be adjusted within the angles shown below.
Grasp the sides of the LCD panel, then adjust screen
angles.
(GB)
Digital RGB
28–75 kHz
60 Hz
1,600 × 1,200 or more*
1,920 × 1,200 or less
approx. 0°-20°