Sony SDM-H246W Manual De Instrucciones página 40

Adjust the height of the monitor
This monitor can be adjusted to two different heights of 0 mm (0
inches) (default setting) and of approximately 20 mm (
as illustrated below.
Do not press the LCD monitor when placing or raising the
monitor straight on a desk or a like.
It may affect the uniformity of the screen or damage the LCD
monitor.
1 Remove the back cover.
Back cover
2 Place a soft mat or the like on a flat surface like a
desk.
You may damage the LCD screen and the display itself if you
put the display directly on the desk.
3 Lay the monitor along the edge of the desk.
Soft mat or the
like
3
/ inches)
4
Display
4 Remove the six screws holding the stand in place.
Note
When removing the screws, be careful not to drop the stand on your
foot, etc.
5 Lift the stand slightly to adjust its height.
6 Fix the stand in place with four screws 1. Tighten
the other two screws 2 or store them in a safe
place.
When you raise the monitor to a height of 20 mm, tighten the
four screws at the positions marked "2" on the stand.
Note
After adjusting the height of the monitor, be sure to tighten the four
screws to fix the stand.
11
(GB)
Display height (max):
5
472 mm (18 / inches)
8
Display height (min):
7
452 mm (17 / inches)
8
2
1