Troubleshooting - Optika Italy INSPECTION SYSTEMS Serie Manual De Instrucciones

12. Troubleshooting

Review the information in the table below to solve operating problems.
PROBLEM
I. Optical Section:
LED operates, but field of view remains
dark.
Dirt or dust is visible in the field of view. Dirt/dust on the specimen
The image is not shown on the screen Power supply is unplugged.
II. Mechanical Section:
Coarse focus knob is hard to turn
Focus is unstable
III. Electrical Section:
LED doesn't turn on.
Brightness is not enough
Light blinks
CAUSE
Power supply is unplugged.
Brightness is too low
Dirt/dust on the lenses
Tension adjustment ring is too tight
Tension adjustment ring is too loose
Power supply not connected
Brightness setting is too low
Power supply not well connected
Page 30
SOLUTION
Connect
Set brightness to a proper level
Clean the specimen
Clean the lenses
Connect
Loosen tension adjustment ring
Tighten tension adjustment ring
Check for proper connection
Adjust brightness
Check for proper connection