Replacing The Fuel Filter - Dometic TEC40D Instrucciones De Uso

Ocultar thumbs Ver también para TEC40D:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 73
Servicing the generator
➤ Pour fresh oil into the filler neck (2).
The maximum amount of oil is 1.1 l.
The oil level must be between the maximum and the minimum notches of
the dipstick (1).
➤ Put the dipstick (1) back into the filler neck (2).
10.5

Replacing the fuel filter

A
NOTICE!
Dispose of the drained off fuel in accordance with the local laws
for environmental protection.
There are two fuel filters (fig. 7 2 and 4, page 6) in the generator.
➤ Place a suitable receptacle under the fuel filter (fig. 7 2 and 4, page 6).
➤ Loosen the fastening clips (fig. 7 1 and 3, page 6).
➤ Remove the fuel filter and insert a new one.
➤ Tighten the fastening clips again.
10.6
Servicing the air filter
!
WARNING! Danger of explosions
Do not use diesel oil or solvents with low boiling points for clean-
ing the air filter. They could ignite or explode.
!
CAUTION!
Wear an respirator mask and protection glasses.
A
NOTICE!
Never leave the engine running without an air filter. Otherwise this
quickly wears out the engine.
I
NOTE
If the air filter is dirty, the air flow to the motor is reduced. Check
the filter regularly so that the motor can function properly. Check
this more frequently if the generator is being used in particularly
dusty environments.
24
TEC40D
EN

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido