Securing The Silencer; Installing The Tank And Fuel Supply Line; Mounting The Remote Control - Dometic TEC 29EV Instrucciones De Montaje

Installation
9.3

Securing the silencer

Observe the following instructions when installing the exhaust pipe:
 Do not create any sharp bends which will inhibit the flow of exhaust
fumes.
 Align the manifold (fig. 4 1, page 4) along the housing to ensure greater
damping of vibration.
 Use the exhaust pipe extension to extent the exhaust pipe (fig. 4 2,
page 4) (see chapter "Accessories" on page 19).
Secure the extension to the vehicle floor (fig. 4 3, page 4).
➤ Secure the silencer (fig. 4 4, page 4) as in one of the alternatives shown
in fig. 5, page 4 to fig. 9, page 6.
9.4

Installing the tank and fuel supply line

Please observe the following instructions for the installation location:
 The tank bottom must be positioned at a maximum of 0.3 m below the
bottom of the generator.
 The top of the tank must not be higher than the top of the generator.
➤ Lay the fuel line as straight as possible.
➤ Secure the tank, see fig. 0, page 6 and chapter "Connecting the float" on
page 28.
9.5

Mounting the remote control

Please observe the following instructions for the installation location:
 Observe the length of the extension cable from the remote control to the
generator.
➤ Drill the holes as shown in fig. a, page 7.
➤ Insert the plug into the remote control.
➤ Screw on the remote control.
22
All manuals and user guides at all-guides.com
TEC29EV
EN