Tabla de contenido
Publicidad
means that the buckle is not fully tamper proof and so your child must be taught never
to play with the buckle.
●
Ensure that all parts are locked in place correctly and not penned in the adjustable seats
or doors.
●
Do not use this child seat at home. It's not designed for home use and should only be
used in your car.
●
We recommend using the baby car seat on the back seat of cars.
●
Before each journey check whether the child car seat is installed firmly.
●
The back rest of the child car seat system have to rest flat against the back of the vehicle
seat. If necessary, adjust the head rest of the vehicle seat.
●
The buckle of the safety car seat belt can't too close to the below of armrest. Please
contact the child restraint manufacturer if in doubt about this point (Fig.3-2).
●
When you drive without a child in the child restraint system, always secure the system
with the adult belt.
4. Usage for the age group I
Use of the harness system is only permitted for children of age group I, which means from
9 kg to 18 kg (approx. 9 months to approx. 4 years).
4.1 Setting the shoulder belt height (group I)
Check whether the shoulder belts are set at the right height for your child. The shoulder belts
should be fed Into the belt slots that lie at shoulder height or just above (Fig. 4.1-1).
If the height of your shoulder belts in child car seat is not fit for your child. Adjust the height
of the shoulder belts, please proceed as follows:
Step 1: loosen the harness (see point 4.3) Turn the child seat to the back (Fig. 4.1-2).
Step 2: Slide both of the harness off the harness connector (Fig. 4.1-3).:
Step 3: Slide the belt off the chest pad connector. (Fig. 4.1-4).
Step 4: Now you can pull both chest pads and shoulder belts forward through the belt slots
carefully (Fig. 4.1-5).
Step 5: Now thread the small belts of the chest pads and harness into the corresponding belt
slots (Fig. 4.1-6).
Step 6: Slide both of the chest pads in the chest pad connector, and slide the harness straps
in the harness connector.
Ensure that the belt is positioned correctly in the belt slot and not twisted.
4.2 Securing the child car seat (group I)
Step 1: Place the child safety seat on the vehicle's seat which is fitted with 3-point safety belts
ensuring it is firmly pressed against the car seat backrest (Fig. 4.2-1).
Step 2: Pull out the vehicle belt, thread the belt tongue (incl. vehicle belt) through the Adult
belt route slot (N) to the rear and through the backrest, through the other Adult belt route
slot (N) (on the buckle side) and allow it to lock in place. You will hear "click" (Fig. 4.2-2, Fig.
4.2-3).
30
Publicidad
Tabla de contenido
