Tabla de contenido
Publicidad
5. Usage for age (group II III)
The harness system must be removed from the seat (see point 5.1) when used for these age
groups 15 kg – 36 kg .Only the 3-point vehicle belt system can be used to buckle up the child
car seat.
5.1 Removal of the harness
●
Loosening the harness (see point 4.3), Turn the seat to the back.
●
Slide both of the harness straps off the harness connector (Fig. 5.1-1).
●
Slide the belt of the chest pads off the Chest pad connector (Fig. 5.1-2).
●
Pull the strap till the steel pole gets out of the soft (Fig. 5.1-3 , Fig. 5.1-4).
●
Now you can remove the belts as well as the tongue in an upwards direction (Fig. 5.1-5).
●
Installation of the harness Is carried out In reverse order to removal.
Keep harness with all parts in a safe place, to use in the future.
5.2 Height adjustment of headrest
Regularly check whether the head rest is optimally to your child. The height of the head rest
is set optimally to the size of your child, when their headrest comfortably in the middle of the
headrest.
●
To raise or lower the head rest: pull the head rest adjustment handle (K). You may now
adjust the head rest by turning the handle (Illus. 5.2).
●
Make sure to lock the handle after adjusting the head rest.
5.3 Securing the child car seat with vehicle's belt
The vehicle's 3-point; belt system may only be used to buckle up children of the age groups II
and III (15 kg – 36 kg).
The harness system must be removed from the seat (see point 5.1) when used for these age
groups 15 kg – 36 kg.
Step 1: Place the child safety seat on the vehicles seat ensuring it is firmly pressed against the
car seat backrest (Fig. 5.3-1).
Step 2: Seat your child In the child car seat (Fig. 5.3-2).
Step 3: Pull out the 3-point vehicle belt and place the lap belt on the opposite side of the
buckle under the armrest. (make sure that the diagonal belts and the lap belt on the buckle
side are under the armrest) The lap strap should be worn low down, so that the pelvis is firmly
engaged and the straps should not be twisted. And allow it to the buckle in place. You will
hear "click" (Fig. 5.3-3).
Step 4: Place the diagonal belt goes through the Head belt guide (L) on the side of the
headrest. Make sure that the belt is not twisted. Tighten the adult belts in the direction as
picture shows (Fig. 5.3-3) and the diagonal shoulder belt in the direction of the automatic roll-
up as possible (Fig. 5.3-4).
The satisfactory position of the adult safety-belt buckle relative to the child car seat is as the
Fig 3-2. You can contact the child car seat manufacturer if in doubt about this point
32
Publicidad
Tabla de contenido
