Hilti NURON SC 30WL-22 Manual De Instrucciones Original página 23

2. Remove the battery from the product.
5.4 Installing the saw blade
Check that the blade to be fitted complies with the technical
requirements and that it is well sharpened. A sharp saw blade is an
essential requirement for a perfect cut.
1. Clean the mounting flange and the clamping flange.
2. Slip the mounting flange right way round on to the arbor.
3. Open the lower guard.
4. Insert the new saw blade.
Note the direction-of-rotation arrows on the saw blade and on the
product. They must point in the same direction.
5. Install the outer clamping flange the right way round.
6. Install the clamping screw.
7. Insert the hex key into the saw blade clamping screw.
8. Press and hold down the spindle lock button.
9. Use the hex key to tighten the clamping screw.
10. Check that the saw blade is seated correctly.
11. Insert the hex key into the hole provided for the purpose.
5.5 Removing the saw blade
WARNING
Risk of burns and cut injuries at saw blade, clamping screw and
clamping flange The consequences can be burns and cut injuries.
▶ Wear protective gloves when changing saw blades.
1. Press and hold down the spindle lock button.
2. Use the hex key to slacken the clamping screw.
3. Remove the clamping screw and the clamping flange.
4. Open the lower guard and remove the saw blade.
If necessary, the mounting flange can be removed for cleaning.
5.6 Adjusting the cutting depth
1. Release the cutting depth adjustment clamping lever.
2. Set the cutting depth.
▶ The cutting depth is shown on the cutting depth scale.
For a clean-edged cut, set cutting depth to the thickness of the
material plus 2 mm.
3. Secure the cutting depth adjustment clamping lever.
*2264106*
2
3
4
2264106 English 17