Hilti NURON SC 30WL-22 Manual De Instrucciones Original página 28

Trouble or fault
The product doesn't
restart by itself after
the saw blade has
stalled.
The battery does
not engage with an
audible click.
Product or battery
gets very hot.
Product vibrates
severely
10 Disposal
WARNING
Risk of injury due to incorrect disposal! Health hazards due to escaping
gases or liquids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical
tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local gov-
ernmental garbage disposal or public health and safety resources for
disposal instructions.
Most of the materials from which Hilti products are manufactured can
be recycled. The materials must be correctly separated before they can
be recycled. In many countries, your old tools, machines or appliances
can be returned to Hilti for recycling. Ask Hilti Service or your Hilti sales
representative for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as
household waste!
22 English
Possible cause
The overload cut-out
has been activated.
The retaining lugs on the
battery are dirty.
Electrical fault.
The product is over-
loaded (application limits
exceeded).
The saw blade is in-
stalled incorrectly
Action to be taken
▶ Press the switch-
on interlock and the
on/off button again.
▶ Clean the retaining
lugs and push the bat-
tery in until it engages.
Consult Hilti­ Service
if problem persists.
▶ Immediately switch off
the product. Remove
the battery and keep
it under observation.
Allow the battery to
cool down. Contact
Hilti Service.
▶ Select a product that
is suitable for the
intended purpose.
▶ Install the saw blade
correctly. → page 17
2264106
*2264106*