Safety Instructions For All Saws - Hilti NURON SC 30WL-22 Manual De Instrucciones Original

liquid contacts eyes, additionally seek medical help. Liquid ejected
from the battery may cause irritation or burns.
▶ Do not use a battery pack or tool that is damaged or modified.
Damaged or modified batteries may exhibit unpredictable behaviour
resulting in fire, explosion or risk of injury.
▶ Do not expose a battery pack or tool to fire or excessive temperature.
Exposure to fire or temperature above 130° C (265 °F) may cause
explosion.
▶ Follow all charging instructions and do not charge the battery pack
or tool outside the temperature range specified in the instructions.
Charging improperly or at temperatures outside the specified range may
damage the battery and increase the risk of fire.
Service
▶ Have your power tool serviced by a qualified repair person using
only identical replacement parts. This will ensure that the safety of the
power tool is maintained.
▶ Never service damaged battery packs. Service of battery packs should
only be performed by the manufacturer or authorized service providers.

2.2 Safety instructions for all saws

Cutting procedures
DANGER: Keep hands away from cutting area and the blade.
▶
Keep your second hand on auxiliary handle, or motor housing. If
both hands are holding the saw, they cannot be cut by the blade.
▶ Do not reach underneath the workpiece. The guard cannot protect
you from the blade below the workpiece.
▶ Adjust the cutting depth to the thickness of the workpiece. Less than
a full tooth of the blade teeth should be visible below the workpiece.
▶ Never hold the workpiece in your hands or across your leg while
cutting. Secure the workpiece to a stable platform. It is important to
support the work properly to minimise body exposure, blade binding, or
loss of control.
▶ Hold the power tool by insulated gripping surfaces, when performing
an operation where the cutting tool may contact hidden wiring.
Contact with a "live" wire will also make exposed metal parts of the
power tool "live" and could give the operator an electric shock.
▶ When ripping, always use a rip fence or straight edge guide. This
improves the accuracy of cut and reduces the chance of blade binding.
▶ Always use blades with correct size and shape (diamond versus
round) of arbour holes.
hardware of the saw will run off-centre, causing loss of control.
6 English
Blades that do not match the mounting
2264106
*2264106*