Triton TA235CSL Instrucciones De Uso Y De Seguridad página 13

All manuals and user guides at all-guides.com
SYMPTOM
Vibration or abnormal noise
Motor runs but blade won't
spin
Saw depth adjustment not
holding
Heavy sparking occurs inside
motor housing
Retractable guard will not
close, or is slow to close
PROBLEM
Accessory not secured
Moving parts excessively worn
Mechanical obstruction
Armature has shorted sections
Blade retaining nut is loose
Broken gear shaft or teeth
Depth adjustment lever requires
tightening
Brushes not moving freely
Armature short circuited
or open circuited
Commutator surface not clean
Return spring detached
or broken
Guard is bent
Mechanism fouled
by sawdust
SUGGESTED REMEDY
Ensure that the saw blade is fully tightened
in the arbor washers
Use authorised service centre**
to repair or replace
Use authorised service centre**
to repair or replace
Use authorised service centre**
to repair or replace
Tighten blade retaining nut,
ensure the arbor washers are correctly fitted
Use authorised service centre**
to repair or replace
Reposition the depth adjustment lever as
described in 'Adjusting the depth locking
lever tension'
Disconnect power, remove brushes, clean
or replace
Use authorised service centre**
to repair or replace
Use authorised service centre**
to repair or replace
Re-attach or replace spring
(use only genuine Triton replacement parts)
Straighten it or contact authorised service
centre** to repair or replace
Clean and lightly lubricate fouled mechanism
Troubleshooting
GB
13