Triton TA235CSL Instrucciones De Uso Y De Seguridad página 8

• Maintain the laser in accordance with the
manufacturer's instructions
CAUTION: Failure to follow safety rules may result in flash
blindness and/or hazardous radiation exposure
1. Rest the front edge of the saw baseplate on the
workpiece. Ensure the blade is not touching your work.
2. Switch on the Laser Sight On/Off Button (8).
PREPARATION
UNPACKING YOUR TOOL
Carefully unpack and inspect your tool. Familiarise
yourself with all its features and functions.
Ensure that all parts of the tool are present and in good
condition. If any parts are missing or damaged, have such
parts replaced before attempting to use this tool.
ADJUSTING THE CUTTING DEPTH
Ensure that the tool is switched
off and disconnected from the
power supply before making
any adjustments or installing or
removing blades.
1. Loosen the Depth Adjustment
Locking Lever (24) and lift
the back of the saw away
from the baseplate until
the approximate depth is
achieved. Push down on the
lever to lock the saw
in position.
2. For fine depth adjustments,
lock the saw at the
approximate depth and then turn the micro depth
adjustment knob for the exact depth. Turn the micro
depth adjustment knob in a clockwise direction to
decrease the depth of cut, turn in an anti-clockwise
direction to increase the depth of cut. The adjustment
range is 6mm, if insufficient, reset the main depth
adjustment, and fine tune again.
The micro-adjustment knob must be set to full depth to
achieve the 82mm maximum depth of cut.
3. The circular saw also features a rack & pinion
depth adjustment feature. The rack & pinion depth
adjustment is most useful when the saw is mounted
below a Triton Workcentre.
4. To adjust the depth using the rack & pinion feature
GB
loosen the Depth Adjustment Locking Lever (24)
and then turn the Rack &
Pinion Adjustment Knob
(23) to adjust the cutting
height. Turn the knob in an
anti-clockwise direction to
increase the cutting depth,
turn in a clockwise direction
to decrease the cutting depth.
8 Preparation
All manuals and user guides at all-guides.com
Note: The laser will not operate if the tool is not plugged
in and switched on at the mains.
3. Line up the beam with your pencil line.
4. Commence the cut.
5. Switch off the laser.
Tighten the depth adjustment locking lever to lock the
saw in position.
ADJUSTING THE DEPTH LOCKING LEVER TENSION
If the Depth Adjustment Locking Lever (24) is not
providing enough tension adjust as follows:
1. Loosen and remove the 2
Phillips head screws that
secure the Rack & Pinion
Adjustment Knob (23).
Remove the adjustment
knob, this will reveal the
locking lever tension nut.
2. Using a 10mm wrench
tighten the tension nut in
a clockwise direction to
increase the tension of the
Depth Adjustment Locking
Lever (24).
3. Once the locking lever is
providing sufficient tension
replace the adjustment knob and
secure using the 2 Phillips head
screws.
4. Check the operation of the
locking lever before operating
the saw.
ADJUSTING THE BEVEL ANGLE
1. Bevel angles can be set anywhere within the range 0°
to 47°. Pre-set stops are available at 0°, 15°, 22.5°,
30° and 45° for quick, accurate bevel settings.
2. Loosen the Front and Rear Bevel Lock Knobs (13 and 4)
and depress the Bevel Detent Latch (12). Pivot the saw
to the angle you require then release the detent latch. A
small movement of the saw motor will allow the latch to
pop up into the detent position. Tighten both bevel lock
knobs.