General Description; Preparation For Use; Temperature Setting - Cole-Parmer INC-200 Serie Manual Del Usuario

Thank you for purchasing this piece of
Cole-Parmer equipment. To get the best
performance from the equipment please read
these instructions carefully before use.
For your own safety and that of others please
read and understand the safety advice given in
section 9.0 of this manual before using the
equipment.
If the equipment is not used in the manner
described in this manual the protection provided
might be impaired.

1 General description

CAUTION: Keep fingers clear when
operating door.
CAUTION: Use care when removing
vessels from the incubator as parts may
be hot.
The INC-200D-M mini incubator has been
specially designed for accurate temperature
controlled life science applications. The stainless
steel chamber features 4 shelves which are easy to
slide in and out or quick loading and unloading.
The INC-200D-H Hybridisation incubator /shaker
features advanced temperature controlled forced
air circulation with clear bright LED digital
temperature display. The unit comes complete
with a seven bottle rotisserie which rotates on
guided rollers. Rotation speed is variable between
2 and 10 rpm. A platform is fitted to the back of
the incubator which drops forward to form a
1 2
Figure 3: Front panel controls
Rotisserie / shaker controls (INC-200D-H only)
1. Rotisserie/shaker ON/OFF button
2. Rotisserie/shaker speed selector dial
3. Motor on indicator
3 4
rocking shaker with variable speed of 10 to 50
oscillations per minute. A rotisserie for two 70mm
diameter bottles is available as well as a range of
specially designed hybridisation bottles.

2 Preparation for use

2.1 Remove all packaging and place the incubator
on a level working surface, ensuring that there
is sufficient room above the instrument to
allow the door to be opened fully.
2.2 Leave the unit to stand for a minimum of 3
hours. This will allow acclimation to the new
ambient temperature.
2.3 Follow the instructions for Electrical Installation
given in section 8 of this manual and connect
the instrument to the electricity supply.
2.4 Connect the power cable to a suitably
grounded electrical outlet. The correct
operating voltage of the incubator is found on
the product information label on the rear of
the instrument.
2.5 Turn the Mains ON/OFF switch located at the
back of the unit ON.
2.6 The incubator is now ready for use.

3 Temperature setting

(model INC-200D-M & INC-200D-H)
3.1 The incubator temperature controls are
located on the right hand side of the control
5
Temperature controls (INC-200D-M &
INC-200D-H)
4. Temperature on / off button
5. Press to set button
6. LED temperature display
7. Temperature selector dial
6 7
1