General Operation; Care And Maintenance - Sinbo SHD 7005 Manual De Instrucciones

GENERAL OPERATION

1. Preheat the curling iron by resting the curling iron (use the heel rest) on a smooth flat
surface and plug into a 220 volt AC outlet. When the red dot on the barrel turns white,
the iron is ready for use. (About five minutes).
2. Hair should be clean and dry and free from all dirt, hair spray, etc. before using the
product. IF you normally set your hair with curlers, section the hair in same pattern.
Start by sectioning hair into strands of no more than 1 inch deep and 2 inches wide.
3. Keep your hair smooth by brushing or combing through the section while holding the
ends tout with on hand.
4. Place the ends of each hair section over the rod, with the clamp open, close the clamp,
making sure that the hair ends extend just beyond the clamp.
5. Grasp the safety tip with other hand.
6. Keep the section of hair taut, while you wind it around the heating rod by turning the
handle with one hand and safety tip with the other.
7. Wind the curl toward your scalp as far as you can go without touching the scalp with
the hot iron.
8. Hold the curl in place for up to 20 seconds for tight curls, less time for loose curls.
Unwind about half a turn, when ready to release the hair. For long hair unwind a little
further push the clamp release bar to open the clamp and withdraw the heating rod from
the center of the curl.
9. For bouncy, flip-up styles, the clamp should be over and the rod under the section of
hair
Brush Attachment
For softer waves and body use the brush attachment, slide the brush attachment over
the tong. Separate a section of hair and wind around brush, hold in place for approximately
10 Seconds and gently unwind. Allow hair to coil fully before styling.

CARE AND MAINTENANCE

This appliance is intended for household use. Unplug product before cleaning. The product
must be cleaned only when cool.
Use a soft non-abrasive cloth that is slightly dampened with water to wipe styling barrel
surface. Do not allow water or any other liquid to get into the handle of the iron. Any
other servicing should be performed by a qualified service center.
The product should not be stored while hot or plugged in. When not in use, allow curling
iron to cool, then simply put back in the box and store out of reach of children in safe,
dry location, never wrap the cord around the curling iron. This could cause the cord to
wear prematurely and break.
- 8 -