Descargar Imprimir esta página

Sinbo SHD 2694 Manual De Instrucciones página 8

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 19
ENGLISH
SINBO SHD-2694
Electric Curling Iron
Use and Care Book
5
2
PARTS NAME
1. Cool Tip
2. Chrome Curling Rod
1
3. On/Off Light
4. On/Off Switch
6
4
3
5. Swivel Cord
6. Built-in Safety Stand
This appliance is for household use and may be plugged into any AC electrical outlet
(ordinary household current). Do not use any other electrical outlet.
To Use: For a complete styling hair should be clean, dry and free from dirt hair spray,
creams, etc.(Of course this iron can always be used for quick touchups and rescues any
time
Pre-Heat: Rest the iron its safety on a smooth, flat surface and plug in. Set the heat
switch at Hi or Low position and allow iron to heat(about 5 minutes) Use Hi heat for
normal, easy-to-curl hair and for hard-to curl hair, simply holding hair wound around
barrel a bit longer for hair that resists curling. Use low heat for hair that has been color
treated, or is fragile or damaged.
Styling: Start by sectioning hair into strands of not more than 1 inch deep and 2 inches
wide. Keep the hair strand smooth by brushing or combing through the section while
holding the ends taut with the other hand. Taking one section at a time, place the ends
of hair over the barrel with the clamp open. Then close the clamp, making sure that the
ends extend just a tiny bit beyond the clamp, grasp the cool safety tip with the other hand,
and it will be casy to roll hair.
Keep the section of hair taut as you wind it around the hot barrel by turning the handle
with one hand and the cool safety tip with the other. Wind the curl toward your scalp as
a far as you wish to go without touching scalp with the hot barrel.
To Use: Hold the curl in place for up 20 seconds for tight curls or is hair is hard to curl.
Hold for less time is hair is easy to curl, or if you want loose curls or just waves. When
you are ready to release curl, unwind about half a turn (for longer hair, unwind a bit
more) and push down on the clamp release lever to open the clamp. Now gently withdraw
the barrel from the center of curl. Allow curl to cool, and try not to disturb curls as you
proceed in the same manner around whole head. When completely finished, and all curls
have cooled thoroughly gently brush and comb hair into the style you wish.
- 7 -

Publicidad

loading