Important - Evenflo BABY ACTIVE exer saucer 61912186 Manual Del Usuario

Assembling the ExerSaucer
F
F > !
5. Place Seat Ring upside down and locate the wheel holders
F
Click six (6) Seat Wheels into wheel holders, as shown.
G
H
F
F > @
6. Align triangles on the back of the Seat Ring with the triangles
F > @
seat pad label. Snap the plastic tabs
Seat Ring. Continue this process until all tabs are attached to all pegs.
To remove Seat Pad:
Un-clip plastic tabs from pegs
H > @
F
CLICK!
D
G
CLICK!
.
F > !
H > !
CLICK!
H > !
on the pad over the pegs
H > @
on the Seat Ring and lift out.
F > #
7. Press Seat Ring down firmly onto
F
the top of the Tray until it locks in
D
place with an audible click, and spins
freely.
4
D > !
H > @
F > #
on the
on the
F > #
To prevent serious injury or death make sure the metal retainer plates
are fully inserted in the retainer slots and resting against tray.
• During use, allow the baby's toes only to touch the floor. DO NOT allow
the baby to stand flat-footed on the floor. As baby grows and becomes
more active, raise the Tray to the next level so that baby enjoys the most
comfortable fit and maximum use of the spin, and bounce features.
• NEVER allow child to stand on tray.
• ALWAYS make sure the metal retainer plates are fully inserted in the
retainer slots before placing child in the ExerSaucer.
Assembling the ExerSaucer
To adjust height:
ALWAYS remove baby from ExerSaucer
before adjusting.
Push tab to remove metal plate
D > !
Insert metal plate E > ! into appropriate slot
to obtain the desired height of the Tray
Repeat for the other two Leg Caps.
IMPORTANT: When inserting Leg Cap plates,
use the same slot in each of the other two
Leg Cap retainers, or the ExerSaucer will not
be level.
E > !
1
Shorter child
2
3
4
Taller child
WARNING
5
.
E > !
.
D