Hinkley TURBINE 904280FCW-LWD Manual Del Usuario página 16

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATION
Your DC brushless motor is equipped with
an automatically learned type remote control.
There is no frequency switches on the
receiver or transmitter. The fan can start to
use once the pairing process is done.
Remove the panel from the transmitter and
then install one 2032 battery (included). You
need to use a coin to open or close the battery
cover. To prevent damage to transmitter,
remove the battery if not use for long periods
of time (Fig. 1)
WARNING: Chemical Burn Hazard.
Keep batteries away from children.
This product contains a lithium button/coin
cell battery. If a new or used lithium button
/coin cell battery is swallowed or enters the
body, it can cause severe internal burns
and can lead to death in as little as 2 hours.
Always completely secure the battery
compartment. If the battery compartment
does not close securely, stop using the
product, remove the batteries, and keep it
away from children. IF you think batteries
might have been swallowed or placed inside
any part of the body, seek immediate medical
attention.
The batteries shall be disposed of properly,
including keeping them away from children;
Even used cells may cause injury.
14
| hinkley.com
1
button:
Press this button and release instantly
to turn on or off the light.
2
button:
Press and hold to dim or brighten
lights to the desired level and release.
3
button:
Press this button to set fan wind
direction up or down.
4
button:
Press button for turn on and setting
1-6 fan speed.
5
button:
Press this button to turn the fan off.
6
Signal light (Fig. 2)
Pairing Process
NOTE: If installing/pairing more than
one fan in an area, the power must be
disconnected from all fans except the
one fan being paired.
With the fan's power off, restore power to
the fan. Press and hold "
" button for about
5 seconds and release. If optional light kit is
installed, the light kit will flash three times
and the motor spin up for 10 seconds on low
speed. The fan has completed the pairing
process with the wall control and is ready
for use.
NOTE: A single fan can be controlled with as
many as 3 wall controls in one room. Every
control will need to repeat the pairing
process based on instructions above and
all controls must be within 30 feet of the fan.
Fig. 1
Signal light
Fig. 2
HIRO Control System
ON
OFF

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Turbine 904280fmb-lwdTurbine 904280fmm-lwd

Tabla de contenido