Hinkley TURBINE 904280FCW-LWD Manual Del Usuario página 9

REMEMBER
to turn off the power before you begin.
To properly install your ceiling fan, follow the steps below.
Slip the yoke cover, trim ring and canopy onto the downrod.
6
(Fig. 3)
7 Slide the hanger ball onto the downrod, insert the cross pin
through the downrod and tighten. Tighten the set screw.
8
Lift ball/downrod/fan into hanger bracket opening.
NOTE:
6 feet of lead wire is supplied on the fan for use with
longer downrods.
INSTALLATION OF SAFETY CABLE SUPPORT
Attach the wood screw and the flat washer to the ceiling joist as
shown (do not fully tighten). Slide the cable clamp onto the safety
cable from the fan. Loop the safety cable around the wood screw
that was just attached to ceiling joist. Feed the end of the cable
into the clamp and pull as much cable through as possible. Firmly
tighten screw in the clamp. Cut off excess cable.
Ground wire
Hanger ball
Hook-up (3) wires
Downrod
Yoke cover
Top of
fan body
Fig. 3
Wood ceiling joist
Safety cable clamp
Safety cable loop
Wood screw
And washer
Safety cable
Fig. 4
Cross pin
Set screw
Safety cable
Canopy
Trim ring
07
©2021 Hinkley Lighting, Inc. | hinkley.com