Bosch SensorSteam TDS12 Serie Instrucciones De Uso página 15

Trouble shooting guide for minor issues
Problem
The iron does not heat up. 1. Temperature control (14) set to
2. No mains supply.
3. The "SensorSteam" system has been
"ActiveControlAdvanced" The "SensorSteam" system has been
indicator lamp (2) flashes. activated. The iron is set to stand-by.
Iron difficult to slide on the Clothing is too wet.
clothing.
The clothes tend to stick. The temperature is too high.
Water drips out of the 1. Temperature control (14) setting is
soleplate together with
steam. 2. Steam control is set too high in
3. You have pressed the shot of steam
4. Pure distilled water has been used
Steam does not come out.
1. Steam control is set to "
2. No water in the tank (10).
3. The temperature is too low. Anti-drip
Spray does not work. 1. No water in the tank (10).
2. Obstructed mechanism.
Smoke comes out when This may be caused by the lubrication
connecting the iron for the of some of the internal parts.
first time.
Deposits come out through Traces of lime scale are coming out of
the holes in the soleplate the steam chamber.
If none of the above solves the problem, get in touch with an authorised technical service.
You can download this manual from the local homepages of Bosch.
All manuals and user guides at all-guides.com
Probable cause
minimum.
activated. The iron is set to stand-by.
too low.
conjunction with a low temperature.
button (5) repeatedly without waiting
for 5 seconds between each press.
(see "Filling the water tank" section)
or other products such as fragrant
water have been added to the tank.
" position.
system is activated.
Solution
1. Turn to a higher position.
2. Check with another appliance or plug the
iron into a different socket.
3. Grip the handle (1) of the iron to re-start
it.
Grip the handle (1) of the iron to re-start it.
Reduce the steam amount by selecting
"eco" or " " settings.
Turn the temperature control (14) down and
wait until the iron has cooled down.
1. Turn the temperature control (14) to a
higher setting (between "••" and "max")
and wait until the green steam setting
indicator lamp stops flashing.
2. Set the steam control to a lower setting.
3. Wait 5 seconds between each press of
the jet of steam button.
4. Mix distilled water with tap water as
directed in the "Filling the water tank"
section and never add any other products
to the water tank (unless recommended
by Bosch).
1. Set the steam control to "eco" or "max"
position.
2. Fill the tank (10).
3. Set to a higher temperature if compatible
with the fabric.
1. Fill the water tank (10).
2. Contact the Technical Service.
This is normal and will stop after a few
minutes.
Carry out a cleaning cycle (see "calc'n
clean" section).
en
15