PAR. 3
SUPPLIED ACCESSORIES
The autoclave is sold with the accessories included
in the article and contained in the same package;
here is a list of these accessories.
PIECE No.
1
Tray extraction and door adjusting key
4
Tray
1
Instruments holder
1
Funnel
1
Tank outlet hose
1
Rilsan hose
1
Sponge
1
Tray holder
1
Loading hose + filter
THE EQUIPMENT LISTED ABOVE DO NOT
REQUIRE ADVICES
NOTE: FOR ALL REFERENCE AT THE OPERATIONS SPECIFIED ON THIS MANUAL, TO KEEP AT THE
PRESENT TABLE.
PAR. 5
To replace the printer roll, it is necessary to open the door on the autoclave front panel, insert a roll of
thermal paper (whose maximum width must be of 57 mm) in the suitable place making the paper come out
from the door while it is closed.
After the sterilisation cycle, the autoclave finishes to print the convalidation ticket; after printing, cut the ticket
by pulling it upwards. The cutter built in the printer will cut the ticket.
Pay attention to the thermal paper orientation sense; it can be printed only on one side.
For a correct and long storage of the sterilisation ticket, it is necessary to preserve the same in a
place protected by light and heat sources.
DESCRIPTION
REPLACING THE PRINTER ROLL
PAR. 4
PUSH-BUTTON AND DISPLAY ON THE
CONTROL PANEL
The positions indicated on the table are referred on
the pictures at the page 3 of the cover.
1A
Display DATE
2A
Display H – MM
3A
TEMPERATURE Display
4A
TIME/MESS Display
5A
134°C cycle Led, not wrapped
6A
134°C cycle led, wrapped
7A
121°C cycle Led, not wrapped
8A
121°C cycle Led, wrapped
9A
134°C cycle Led, SPECIAL
10A
Clean water Led, maximum level
11A
Used water led, maximum level
12A
0/1 (START/STOP) push-button
13A
Cycle selection push-button
14A
Door opening push-button
15A
Clean water Led, minimum level
16A
Push-button for water loading in the clean
water tank
17A
ON/OFF main switch
18A
Door opening handle
19A
Adjusting feet
20A
Autoclave door
21A
Printer
22A
Cap manual filling
23A
Discharge tap
24A
PRESSURE Display
25A
Water loading plug
18
DNVT008 Rev_1