Operational Summary; Diopter Adjustment; Continuous Measurement Mode - Nikon Forestry Pro Manual De Instrucciones

Operational Summary

Caution—use of controls or adjustments or
En
performance of procedures other than those
De
specified herein may result in hazardous radiation
Fr
exposure
Es
1. Install a battery in the battery chamber. (See "Changing
Batteries")
It
2. Rubber eyepiece cup
Ru
Eyeglass wearer: Collapse the eyepiece cups.
No
Non-eyeglass wearer: Do not collapse the eyepiece cups.

3. Diopter adjustment

Se
Adjust diopter to obtain a clear image in the LCD.
Fi
First, rotate the diopter adjustment ring counterclockwise
until it comes to a complete stop. Next, turn on the power
Nl
to activate the LCD when you look through the Nikon Laser
Dk
Forestry Pro. Rotate the diopter adjustment ring clockwise
until the display comes into focus.
Ro
If the diopter is not adjusted to correspond to your
Pl
eyesight, you may not be able to clearly focus your subject.
4. Measuring
Hu
Note: See the chapter "External and Internal display" for external
Cz
LCD panel.
all symbols to be displayed in the internal LCD panel. After
button then remove your finger, the LCD panel may
display the last-used setting without displaying all of the
symbols. This is not a malfunction or other problem.)
Before measuring, be sure to confirm settings, such as unit,
measurement/display mode and priority mode.
◎
: See the relevant mode section in this manual for setting.
14
All manuals and user guides at all-guides.com
LCD is illuminated
◎
Set your desired modes
Align the reticle
☆
with the target
For continuous distance
and angle measurement
(up to 20 seconds), keep
button depressed.
appears
or
※
Indication
Results are converted
remains
to the mode set and
illuminated for
displayed.
30 sec.
30 seconds pass without operation ＊
Power off: LCD indications disappear
※ See the the chapter "External and Internal display" for details
regarding the operations and results display of the various
modes."
＊ Power turns off 30 seconds after the last operation.
☆【Continuous measurement mode】
perform continuous measurement for 20 seconds.
Blinks while performing measurements.
Target Priority and Continuous measurement mode for easy
smallest number is the distance to your targeted pin.
5. Selecting display unit (Factory default setting is feet.)
Yard [ ] Feet
[ ]
1. Confirm the LCD panel is on.
2. Press and hold the button for approx. two seconds.
button.
4. Repeat steps 2 and 3 until your desired mode is displayed.
and displayed in the your selected measurement unit.
6. Switching measurement/display modes (Factory default
setting is linear distance measurement mode)
Horizontal Distance [
Linear Distance [ ]
Height [ ] Angle [
Vertical Separation
Three-point measurement
(height between 2
[
[ ]
points )
indicated above.
1. Confirm the LCD panel is on.
2. Press button within 0.5 seconds.
[ ]
3. Release button to switch the mode.
4. Repeat steps 2 and 3 until your desire mode is displayed.
5. Switching the mode after measurement converts the
results to the new mode.
6. After the mode is set, measurements are performed in the
new mode.
En
De
]
Fr
Es
]
It
Ru
No
]
Se
Fi
Nl
Dk
Ro
Pl
Hu
Cz
15