Base Settings; Expanded System (+1) - Doro 620 Manual

Base settings

System PIN is 0000 on delivery.
1. Press . Scroll to Setup BS. Press
w
2. Scroll to desired function e.g. Access Code. Press
3. Enter the required setting. Press
Change PIN
Dial Mode
Flash Time
Access Code
Set back

Expanded system (+1)

The following functions only apply to +1 systems. It is NOT possible to add additional
handsets at a later time. The base unit should be centrally positioned so that the area covered
is roughly equal for both handsets.
INT calls
1. Press . Scroll to Call intern. Press
w
2. Enter the allocated number of the handset that you wish to call,
A tone will be heard if an external call comes in while an internal call is in progress. You must
then terminate the internal call by pressing
by pressing .
q
Transferring calls/Conference between handsets
1. While an external call is connected on line.
2. Initiate an internal call as described above.
3. Press to transfer the call OR press
q
English
All manuals and user guides at all-guides.com
.
0
.
0
You can change the PIN code (0000 on delivery).
The dial mode setting should be Tone.
Only for adaptation to international company switchboards.
The normal setting is 100 ms. (600 ms in New Zealand).
Enter the digit that obtains an external line and the telephone will
insert a pause automatically when a number starts with that digit.
Resetting the base unit.
.
0
q
, scroll to Conference and then press
w
.
0
, in order to be able to receive the external call

-
1 4
.
0