Switching The Clipper On And Off; Using The Clipper; Replacing The Clipping Blades - Heiniger XPLORER Traducción Del Manual Original

6.6

Switching the clipper on and off

Fig. 9
6.7

Using the clipper

Approach the animal from the front.
X
Secure the animal to be clipped and calm it down.
X
Switch the clipper on while you are in the visual range of the animal.
X
Observe the animal's behaviour while clipping.
X
Switch the clipper off after you have finished clipping.
X
6.8

Replacing the clipping blades

Fig. 10
Fig. 11
Fig. 12
14
To switch the clipper on, slide the ON/OFF switch to
X
the position I.
To switch the clipper off, slide the ON/OFF switch to
X
the position 0 (see Fig. 9).
Switch the clipper off by sliding the switch to the po-
X
sition "0".
Turn the adjusting knob in the direction of the arrow
X
until the resistance decreases.
Place the clipper with the comb plate screws facing
X
upwards on a flat surface.
Loosen the comb plate screws and remove the
X
clipping blades.
Translation of the original instructions / Cattle and Horse Clipper
NOTE!
Make sure the clipping blades are positioned
X
correctly when installing the new or sharpened
blades.