Heiniger XPLORER Traducción Del Manual Original página 35

Malfunction
Play between pivot
lever and leaf spring.
Pivot lever difficult to
move up and down.
Clipper cuts badly or
not at all
Motor does not run or
stops immediately.
Motor runs very
slowly.
Motor unit
becomes hot.
Running time of a fully
charged battery is too
short and / or blades
are getting hot.
Translation of the original instructions / Cattle and Horse Clipper
Cause
Leaf springs and/or cylinder
head screws worn.
Centring sleeve lost.
Clipper blades blunt
Clipper blades have not been
correctly ground
Clipper blades are not oiled
Clipping pressure too low.
Leaf springs broken.
The animal's hair is wet.
Hairs jammed between top
and bottom blades.
Too much play at the clipping
head.
Clipping blades not properly
aligned.
Clipping pressure too strong.
Battery is dead.
Contacts dirty.
Faulty battery.
Smell of burning from the mo-
tor housing. Motor burned out.
Clipperhead blocked.
Motor and/or electronics
defective.
Clipper blades were not oiled
sufficiently.
Clipping pressure too strong.
Battery almost discharged.
Motor and/or electronics
defective.
Clipping pressure too strong.
Motor faulty.
Clipper blades were not oiled
sufficiently
Flat, not fully charged or faulty
battery is being used.
Rectification
Notify customer service.
Notify customer service.
Notify customer service.
Lubricate the clipping blades every
15 minutes.
Increase the clipping pressure,
as described in chapter 6.5.
Notify customer service.
Only clip dry hair.
Remove the clipping blades; clean,
lubricate and install them again; set
the clipping pressure.
Notify customer service.
Align the clipping blades correctly, see
Fig. 14.
Reduce the clipping pressure, as de-
scribed in chapter 6.5. Have the
blades sharpened.
Charge battery.
Switch clipper off and clean
the contacts.
Replace battery.
Notify customer service.
Remove jamming.
Notify customer service.
Lubricate the clipping blades.
Reduce the clipping pressure, as de-
scribed in chapter 6.5.
Charge battery.
Notify customer service.
Reduce the clipping pressure, as de-
scribed in chapter 6.5.
Notify customer service.
Oil clipper blades.
Only use intact, fully charged original
batteries.
17