Using An Aux Source - Pioneer DEH-1500UB Manual De Instrucciones

Operating this unit
For details, refer to System menu on page 7.

Using an AUX source

1 Insert the stereo mini plug into the AUX
input jack.
2 Press SRC/OFF to select AUX as the
source.
Note
AUX cannot be selected unless the auxiliary set-
ting is turned on. For more details, refer to AUX
(auxiliary input) on the previous page.
Switching the display
Selecting the desired text information
1 Press DISP to cycle between the following:
! Source name
! Source name and clock
If an unwanted display appears
Turn off the unwanted display using the proce-
dures listed below.
1 Press M.C. to display the main menu.
2 Turn M.C. to change the menu option
and press to select SYSTEM.
3 Turn M.C. to display DEMO OFF and press
to select.
4 Turn M.C. to switch to YES.
5 Press M.C. to select.
All manuals and user guides at all-guides.com
Installation
Connections
! When installing this unit in a vehicle without
an ACC (accessory) position on the ignition
switch, failure to connect the red cable to the
terminal that detects operation of the ignition
key may result in battery drain.
! Use of this unit in conditions other than the
following could result in fire or malfunction.
— Vehicles with a 12-volt battery and negative
— Speakers with 50 W (output value) and 4 W to
! To prevent a short-circuit, overheating or mal-
function, be sure to follow the directions
below.
— Disconnect the negative terminal of the bat-
— Secure the wiring with cable clamps or adhe-
— Place all cables away from moving parts,
— Place all cables away from hot places, such
— Do not connect the yellow cable to the battery
— Cover any disconnected cable connectors
— Do not shorten any cables.
— Never cut the insulation of the power cable of
— Use a fuse of the rating prescribed.
Autogood products «130»
Important
ACC position No ACC position
grounding.
8 W (impedance value).
tery before installation.
sive tape. Wrap adhesive tape around wiring
that comes into contact with metal parts to
protect the wiring.
such as the shift lever and seat rails.
as near the heater outlet.
by passing it through the hole to the engine
compartment.
with insulating tape.
this unit in order to share the power with
other devices. The current capacity of the
cable is limited.
— Never wire the negative speaker cable directly
to ground.
— Never band together negative cables of multi-
ple speakers.
! When this unit is on, control signals are sent
through the blue/white cable. Connect this
cable to the system remote control of an ex-
ternal power amp or the vehicle's auto-anten-
na relay control terminal (max. 300 mA
12 V DC). If the vehicle is equipped with a
glass antenna, connect it to the antenna
booster power supply terminal.
! Never connect the blue/white cable to the
power terminal of an external power amp.
Also, never connect it to the power terminal
of the auto antenna. Doing so may result in
battery drain or a malfunction.
! The black cable is ground. Ground cables for
this unit and other equipment (especially,
high-current products such as power amps)
must be wired separately. If they are not, an
accidental detachment may result in a fire or
malfunction.
This unit
1 2
3 4 5
1 Power cord input
2 Rear output or subwoofer output
3 Antenna input
4 Fuse (10 A)
5 Wired remote input (DEH-1500UBG, DEH-
1500UBB and DEH-1500UB only)
Hard-wired remote control adapter can be
connected (sold separately).
Section
02
03
9
En