Extremis Sensu Single square Manual página 35

Rotate 360° - p30
1. Turn the rotating pin 180° to unlock the pole.
2. Now take the corner of the fabric to turn the
shade easily.
3. When in the desired position, lock the rotating
pin by turning it back 180°.
Tilting vertically - 32
1. Us the handle to move the shade up / down.
2. Fix the handle when the shade is in the desired
position.
With permanent fixation - p14
1. Tape the bottom side of the tube to make sure no
concrete gets inside the tube.
2. Make a well as shown in the drawing.
3. Place the anchor in the middle of the well and
make sure the anchor is perpendicular.
4. Fill the well with concrete.
5. Make sure the top of the anchor is aligned with
the disired floor.
6. Check if the anchor is still perpendicular and let
it rest for a while until the concrete is hard.
7. Fix the rotating system to the anchor and fix with
4 bolts M10x16. Or place the included cover plate
when not using the rotating system.
8. Take the included parasol support out of the pole.
9. Position the parasol support on top of the
rotating system. Make sure that the cutout is
positioned with the rotating pin is shown in the
drawing.
10. Now position the small cover plate on top.
11. The tilted side of the parasol support is back side
of the shade. Attention: make sure the shade is
tilted backwards as shown in the drawing.
12. Now slide the parasol pole on top of the parasol
support as shown in the drawing.
13. Tighten the two adjusting screws on the back of
the pole.
MAINTENANCE
Powder coating
CLEANING
Regularly
Use Extremis Multicleaner, a 100% biodegradable
detergent or common kitchen cleaning products.
Avoid using aggressive products. These surfaces are
best cleaned with a neutral cleaning product diluted
in water.
REMOVING STAINS
Only if nothing else helps
The magic eraser gets rid of most stubborn stains
without effort. Only if stubborn stains remain visible
after treatment according to the instructions, you
can use the Extremis Magic Eraser sponge. This
sponge is made of melamine resin and wears away
with use. The sponge is very easy to use and gives
results up to 26 times faster than a traditional mi-
crofibre cloth. The magic sponge is the solution for
getting rid of stubborn stains such as felt-tip pens,
grease, scuff marks, limescale marks or coffee and
tea stains. The magic sponge can be used on tar-
paulin fabric, plastic profiles, glass, steel, chrome,
aluminium, porcelain, artificial leather and many
types of floor.
REPAIRING DAMAGED POWDER COATING
When damaged
The impact of sharp objects can damage the
coating. Scratches or dents can be touched up with
our paint pens. However this only camouflages the
scratches without removing them.
Acrylic fabric
CLEANING
When dirty
Make a solution to remove stains.
REMOVING STUBBORN STAINS
Only if nothing else helps
More drastic measures needed? Bleach can be used
if nothing else helps. Protect the area around your
fabric when using a bleach solution – bleach may
discolor fabrics. Please be aware of the environment
when cleaning with bleach. Bleach can have harmful
effects on the natural environment around you. We
do not advise using bleach if you are surrounded by
a body of water or another environment that could
be affected. If stains and/or mildew marks are seve-
re, the quantity of bleach may be increased.
Watch the maintenance video on
our website:
www.extremis.com/maintenance
35