Milwaukee 0233-20 Manual Del Operador página 2

READ AND UNDERSTAND ALL INSTRUCTIONS
Failure to follow all instructions listed below, may result in
electric shock, fire and/or serious personal injury.
WORK AREA
1. Keep your work area clean and well
lit. Cluttered benches and dark areas
invite accidents.
2. Do not operate power tools in ex-
plosive atmospheres, such as in
the presence of flammable liquids,
gases, or dust. Power tools create
sparks which may ignite the dust or
fumes.
3. Keep bystanders, children, and visi-
tors away while operating a power
tool. Distractions can cause you to lose
control. Protect others in the work area
from debris such as chips and sparks.
Provide barriers or shields as needed.
ELECTRICAL SAFETY
4. Grounded tools must be plugged
into an outlet properly installed and
grounded in accordance with all
codes and ordinances. Never re-
move the grounding prong or
modify the plug in any way. Do not
use any adaptor plugs. Check with
a qualified electrician if you are in
doubt as to whether the outlet is
properly grounded. If the tools should
electrically malfunction or break down,
grounding provides a low resistance
path to carry electricity away from the
user.
5. Double Insulated
equipped with a polarized plug (one
blade is wider than the other). This
plug will fit in a polarized outlet only
one way. If the plug does not fit fully
in the outlet, reverse the plug. If it
still does not fit, contact a qualified
electrician to install a polarized out-
let. Do not change the plug in any
way. Double insulation
All manuals and user guides at all-guides.com
GENERAL SAFETY RULES
WARNING!
SAVE THESE INSTRUCTIONS
6.
7.
8.
9.
10. Stay alert, watch what you are do-
tools are
11. Dress properly. Do not wear loose
12. Avoid accidental starting. Be sure
eliminates the
2
need for the three wire grounded power
cord and grounded power supply sys-
tem.
Avoid body contact with grounded
surfaces such as pipes, radiators,
ranges and refrigerators. There is
an increased risk of electric shock if
your body is grounded.
Do not expose power tools to rain
or wet conditions. Water entering a
power tool will increase the risk of elec-
tric shock.
Do not abuse the cord. Never use
the cord to carry the tools or pull
the plug from an outlet. Keep cord
away from heat, oil, sharp edges
or moving parts. Replace damaged
cords immediately. Damaged cords
increase the risk of electric shock.
When operating a power tool out-
side, use an outdoor extension
cord marked "W-A" or "W". These
cords are rated for outdoor use and re-
duce the risk of electric shock.
PERSONAL SAFETY
ing, and use common sense when
operating a power tool. Do not use
tool while tired or under the influ-
ence of drugs, alcohol, or medica-
tion. A moment of inattention while op-
erating power tools may result in seri-
ous personal injury.
clothing or jewelry. Contain long
hair. Keep your hair, clothing, and
gloves away from moving parts.
Loose clothes, jewelry, or long hair can
be caught in moving parts.
switch is off before plugging in.
Carrying tools with your finger on the