Installation; Description Of Parts - Lenco IPT-6 Guia Del Usuario

Clock setting battery back-up
A backup battery compartment is located at rear of the device.
(1) Open the clock battery compartment lid.
(2) Follow the polarity diagram as shown inside of the compartment and install 2 x AAA (UM-4)
batteries (not included).
(3) Close the clock battery compartment lid.
Remote Control
The remote control operates on one DC3V CR2025 type Lithium battery (included).
To activate the remote control, remove the insulation tab attached in the battery compartment.
Warnings:
- Batteries shall not be exposed to excessive heat such as sunshine, fire or likewise.
- Be sure that the batteries are installed correctly. Wrong polarity may damage the device.
- Do not mix old and new batteries.
- Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries.
- Only batteries of the same or equivalent type as recommend are to be used.
- If the device will not be used for an extended period of time, remove the battery.
- Do not dispose of batteries in fire; battery may explode or leak.
- Danger of explosion if battery is incorrectly replaced.
AC power Connection
(1) Connect the AC power cord to power socket at rear of the device.
(2) Firmly and securely plug the power cord's AC main plug into the AC main outlet.
Main Device
9
8
All manuals and user guides at all-guides.com

Installation

Description of Parts

Top View
7 6 5 4
5
12
10
11
3 2 1
13