Radio Preset Stations
The device allows you to store up to 20 FM stations for easy recall at any time.
How to Preset Stations
1.
Press the POWER
2.
Press the FUNC button to select FM radio mode.
3.
Tune to the radio station you want to store in memory by using the TUN
4.
Press the MEM button. The preset channel number appears on display and blinking.
5.
To select desired preset station number, press the CH +/- button.
6.
To confirm preset location, press the MEM button again.
7.
Repeat step 3 to 6 to store other stations.
Notes:
1. After a few seconds of delay, the device will automatically switch back to normal tuner mode.
2. You can overwrite a preset station by storing the new frequency in its place.
Recalling Preset Station
In radio mode, press the CH +/- to select the desired preset radio channel. The preset channel
number will be displayed shortly.
This device can dock different iPod/iPhone models.
How to listen to your iPod/iPhone:
1. Place your iPod/iPhone into the docking port by placing the connector on the bottom of the
iPod/iPhone onto the connector in the docking bay.
Caution: Please be careful when placing the iPod/iPhone into the docking to avoid damaging
the 30-pin connector on the iPod/iPhone or in the docking system.
2. Press the POWER
3. Press the FUNC button to select iPod/iPhone mode. The iPod symbol will appear on the
display.
In iPod / iPhone mode:
- To start playback music, press the
- To pause the music, press the
- To resume music, press the
- Pressing the VOL
Note: The volume level cannot be adjusted by using the volume control on your iPod / iPhone
after being docked.
- During playback, press and hold the TUN
button (on the remote control) to perform forward / backward high speed search.
- To skip to next or previous song, press the TUN
FR button (on the remote control) shortly.
- To turn off the iPod / iPhone, press the
- To turn off the device, press the POWER
- When the device is connected to the AC main power and the iPod/iPhone placed in the
docking station, the device will recharge the iPod/iPhone's battery.
Video Out from the iPod / iPhone
1. Connect this device to a television or to another video display that has a composite video input.
2. Securely dock the iPod (with video) / iPhone.
3. Connect the yellow RCA cable (not included) to the RCA video jack on the rear of the device.
All manuals and user guides at all-guides.com
button to turn on the device.
Listening to iPod / iPhone
button to turn on the device.
button once.
button once.
button again.
/
+/- button adjusts the volume to the desired level.
/
button (on the main device) or FF / FR
/
button (on the main device) or FF /
button for about 3 seconds.
button.
8
/
button.