On-Screen Information - Fermax Meet 1455 Guia De Inicio Rapido

BASIC PROGRAMMING FROM A PC
• Panel programming is done exclusively by means of a
PC connected to the same LAN, through of a web browser
(Chrome preferably), accessing the IP of the panel.
• Default IP is: 10.1.0.1.
• The PC must have an IP of the same range as the IP of the
panel.
Example: In the case that the IP of the panel is 10.1.0.1, the IP of
the PC have to be of type 10.X.X.X with a subnet mask 255.0.0.0
• Assign, as a minimum, the parameters indicated in the following table.
• It is necessary to carry out a previous planning of the installation, to defi ne the parameters
to assign to each device.

ON-SCREEN INFORMATION

It is possible to get basic information on the equipment confi guration through the screen.
1. Dial 9999, followed
by the key "B".
GENERAL
1.LANGUAGE: Select the desired language (default
ENGLISH).
2.TYPE: Choose BLOCK PANEL or G.E. PANEL.
Depending on the selection the fi elds below will be
diff erent
• If BLOCK PANEL
• BLOCK: Block number
• DEVICE NO: Device number in the block. If
there is only one leave it in 1.
• If G.E. PANEL
• DEVICE NO: Entrance number in the installation.
If there is only one, leave it in 1.
3. SIP DIVERT MODE: PARALLEL CALL
Confi rm with SAVE
NETWORK
Indicate the network parameters assigned to this panel:
• IP: Panel IP address
• MASK: Subnet mask
• GATEWAY: IP of gateway
• DNS: Valid DNS IP
Confi rm with SAVE
2. The screen will display information about panel
settins:
• Firmware version
• GENERAL settings
• Serial number
• IP address
• MAC
To login, identify yourself with
the username and password.
Default value:
• Username: admin
• Password: 123456
GUIA RAP INST PLACA MARINE
5