("Clean System™" Function); Preliminary Operations - Jacuzzi SKYLINE 190 Manual De Uso Y Mantenimiento

Sanitisation of
the tub
("Clean System™" function)
preliminary
operations
the function
Pressing the button briefly illuminates
blue; therefore, the light returns white
The sanitization process cannot
be interrupted unless the power is
disconnected via the main switch
The water used for sanitiza-
tion must be emptied as the
liquid irritates the skin.
Jacuzzi recommends disinfectant J-MX 07
centre or authorised retailer. J-MX 07 is a quick-acting, long-lasting disinfectant, ideal for
sanitising the tub plumbing circuits. It degreases, cleans and deodorises, and has a wide
range of uses.
(*) product available in selected countries only. For more information, contact a Jacuzzi ® service centre or authorised
retailer
■ It is possible to carry out this cleaning operation using the same water used for the
hydromassage provided that soap, oils, cosmetics,have not been used; otherwise, empty
the tub and fill it once again.
In any case, the tub water level (free of concentrates) must fully cover the highest jets.
■ Check that the outlet nozzles are open.
Then pour approximately 150 ml of J-MX 07 liquid into the tub water.
activate
To activate the function, press and hold the
■
spotlight – or the hydromassage jet lights for the Illumatherapy™ models) flashes and
pumps will activate (for approximately a minute) to ensure the liquid inside the hydraulic
circuit circulates.
The function lasts approximately 10 minutes and is completely automatic; about one
minute before the end of the function, the pumps activate
■ When the spotlight (or the hydromassage jet lights for the Illumatherapy™ models) stops
flashing, the function is considered complete: open the drain and empty the tub.
25
, which can be purchased at a Jacuzzi® service
(*)
J-MX 07
button for 4 seconds: the tub light (the
the
A
B
once again to rinse the pipes.