Gettiing Started; Phono Mode - Vinyl Record Playback - auna TT-Classic + Manual Del Usuario

EN
18

GETTIING STARTED

• Fix the dust cover onto the turntable.
• Firmly and securely insert the DC plug of the adaptor to the DC IN Jack
on the back of the unit.
• Plug the adaptor's AC plugs into a power outlet.
PHONO MODE – VINYL RECORD PLAYBACK
1. Turn the mode selection knob to PH.
2. Turn the power & volume control knob clockwise. The indicator light
will illuminate red.
3. Place a record on the turntable platter and select the desired speed
(33/45/78) according to the record.
4. When playing a 45RPM record, use the included 45RPM adapter
located in the holder besides the platter(one more 45RPM adaptor can
be found in the accessory bag).
5. Remove the stylus protector. Open the tone arm clip to release
the tone arm. Push the lift lever (it is besides the auto stop switch)
backward to raise the tone arm and gently move the tone arm to the
desired position over the record. You can turn the pitch control knob to
adjust the speed of the platter little by little. The turntable will begin
to spin when the tonearm is moved toward the record(when the AUTO
STOP switch is ON). Push the lift lever forward to lower the tone arm
slowly onto the desired position.
Note: when you push the lift lever forward, do not push it beyond the
position of the tone arm clip) on the record to start playback.
6. If the Auto Stop Control Switch is turned ON, the record will stop
automatically when finished. If Auto Stop Control Switch is turned OFF,
the record will NOT stop automatically when finished.
Remark: AUTO STOP function applies to most 33RPM vinyl records.
However, for very few vinyl records, it will stop when it does not come to
the end(in this case, turn the AUTO STOP switch to OFF position and then
it will continue playback), or it will not stop when it comes to the end when
AUTO STOP is ON.