Bimar FS40R1 Folleto De Instrucciones página 12

All manuals and user guides at all-guides.com
Fax +32 030 9904733
ASSEMBLY
Attention: the fan can be used only when completely and correctly assembled,
that is complete with its base and support and protection grid. In case of doubt,
have the operation checked or carried out by professionally qualified personnel.
Attention: always unplug the appliance before you assemble.
For assembly, proceed as described and take figures as reference.
1) Fix the counterweight to the base (bottom side so that the
figures in relief collimate) with ring nut: pay attention to the
2 pins of the support,
corresponding slots formed on the bottom. Tighten the ring
nut.
2) Engage the lower column (4) to the support so that tabs and
grooves collimate, and for locking rotate anti-clockwise until
it stops.
3) Insert the rack on the rear (12) on the engine crankcase, so
that the handle appears at the top (see figure below), that is
pins and holes correspond to each other, block the rack with
the appropriate ring nut (14).
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar (Italy).
The pages must be reproduced and folded in order to obtain
a booklet A5 (+/- 148.5 mm width x 210 mm height). When
folding, make sure you keep the good numbering when you
turn the pages of the I/B. Don't change the page numbering.
Keep the language integrity.
1) Ring nut
2) Counterweight
3) Base
4) Lower upright
5) Upper upright
6) Control panel
7) Feet attachment screw
8) Adjustable rod
9) Screw for plastic ring
10) Fan
11) Front grille/protective screen
12) Rear grille
13) Motor shaft
14) Grille attachment ring nut
15) Fan attachment ring nut
16) Power cable
which must engage in
12 40
/
Assembly page 12/40
the