Troubleshooting Guide - Honeywell MM14CCSBB Manual Del Propietário

TROUBLESHOOTING GUIDE

The following troubleshooting guide addresses the most common problems. If problems persist, call
customer service. Unplug and disconnect the appliance from the power source before attempting to
troubleshoot.
PROBLEM
The air conditioning
unit does not start
Runs a short while
only
Runs but no cooling
Will not run and
water full indicator
light is ON
All manuals and user guides at all-guides.com
POSSIBLE CAUSE
• No electricity.
• Batteries in the remote control need
to be replaced.
• The power cord is not properly
plugged in.
• The safety LCDI plug has tripped
(USA / Canada / Mexico only).
• The thermostat temperature setting
is too close to room temperature.
• Air outlet is blocked.
• There are tight bends in the air
exhaust hose.
• A door or window is open.
• The air filter is dirty.
• The exhaust hose is detached.
• Temperature setting is too high.
• Air outlet or intake is blocked.
• Excess water condensation inside
the tank.
EN
SOLUTION
• Check for power.
• Change remote control batteries.
• Remove and reconnect the
power cord.
• Reset the safety LCDI plug, if
problem persists contact our
customer support (USA /
Canada / Mexico only).
• Lower the set temperature.
• Make sure the exhaust hose is
properly connected.
• Connect exhaust hose as per
instructions on page 4.
• Make sure the window or door
is closed.
• Clean the air filter.
• Reinstall exhaust hose properly
(refer to Installation section).
• Reduce temperature setting on
control panel.
• Remove blockage.
• Drain the water (refer to Water
Condensation Drainage).
9