General Instructions - JANE CONCORD REVERSO i-PLUS Manual Del Usuario

_ GENERAL INSTRUCTIONS

_This Car Seat is designed to protect the child in the car from 40 cm to 105 cm in height.
_It has passed the rigorous safety tests of European standard ECE R129/03.
_ COMPATIBILITY
_Not all safety systems are exactly the same, therefore we advise you to check the Car Seat in the
vehicle where it is going to be fitted.
_This is an "i-Size" Child Car Seat for use on seats with "i-Size compatibility" as indicated by the
vehicle manufacturer. Please refer to the car manual.
_For vehicles that do not have i-Size seats, the car seat can very probably be fitted on the vehicle
seats.
A compatibility list can be found in the "car fitting" section of the
website: www.janeworld.com
_Do not install the car seat in a sideways or rear facing position, as this is very dangerous.
_WARNING: Be aware of the traffic laws in the country in which you are
driving. The use of your child restraint system may be restricted.
EN
16
_ INSTRUCTIONS
_Read these instructions carefully before using the Car Seat for the first time.
Failure to follow these instructions carefully may put your child's safety at risk.
_Everyone who is going to use the car seat should also be familiar with its
correct installation, use and how to get the child out in the event of an accident.
_Keep the instructions in their compartment, and refer to them as necessary.
You can also find them at: www.janeworld.com or by scanning the QR code
found on the seat itself.
_The instructions in the vehicle handbook should also be observed.
Remember to always secure your baby with the safety harness correctly fastened, fitted snugly
and without any twists.
The support leg must be in contact with the floor of the vehicle.
This Safety Seat is designed for use in the car, and must not be used outside the vehicle.
If in doubt, consult the Safety Seat manufacturer or retailer.
Never leave the child unattended in the safety seat.
EN
17